Table of Contents
Advertisement
piezobrush PZ2
Operating Instructions for Handheld Device
Preliminary data
7.2 Notes on the correct handling of the substrates to be treated
Caution – Electrical voltage!
•
Danger from electrical voltage
-
Never direct the plasma beam at people or animals.
-
Never touch the plasma nozzle or the plasma jet when the device is in operation.
-
Never touch the workpiece to be treated or its holder during plasma generation.
-
Make sure that no third party comes into contact with the workpiece to be treated
or its holder.
-
If electrically conductive materials touch the workpiece to be worked on, these
materials must be grounded.
This applies not only to direct handling of the device, but also to the workpiece to be handled and its holder.
A functional grounding connection is provided on the device for a special form of plasma treatment involving
transferred electric arcs. If you want to use this special application, please contact Relyon Plasma GmbH
directly.
7.3 Carrying out surface treatment
Depending on the type and condition of your substrate, pre-cleaning before the plasma process can improve the
overall outcome.
The effect of the treatment depends on the working distance, treatment time, speed and consistency of
movement as well as the material to be treated.
Ensure that the substrate is not thermally damaged due to movement that is too slow or a working distance that
is too low.
Treatment examples can be requested directly from Relyon Plasma GmbH.
7.4 Measured to take the surface treatment
To achieve an optimal result, it is important that as little time as possible elapse after the plasma treatment and
that the treated surface is not touched or contaminated. Cleaning the surface AFTER the plasma treatment is
not recommended. Since the workpiece can heat up depending on the type and duration of the plasma process,
it may be necessary to allow the workpiece to first cool down first before the next process step is executed in
order to not negatively affect the follow-up process through the introduction of heat (e.g. certain bonding
processes).
Caution – Hot surface!
The workpiece to be treated can become heated up by the plasma process depending on
the process parameters. If necessary, allow the workpiece to cool down before handling it.
Please read Cautions and warnings and
Important notes at the end of this document.
Page 10 of 17
Z63000Z2910Z1Z62
PZ2 - Prototypes
2019-06-12
Advertisement
Table of Contents
