Subscribe to Our Youtube Channel
Related Manuals for Elsema Gigalink GLR43308
Summary of Contents for Elsema Gigalink GLR43308
- Page 1 GLR43308 and GLR2708 Setup and programming instructions for the 8 channel Gigalink receiver ™ Programming Videos www.elsema.com...
- Page 2 The company will not accept Elsema Pty Ltd shall not be liable for any injury, damage, liability for failure to comply with the figures or estimates due cost, expense or any claim whatsoever to any person or...
- Page 3 The receiver’s micro-controller can store unlimited number of transmitters with a high security level using the encrypted 32-bit digital code. Included with the receiver is the Gigalink™ programming cable. TECHNICAL DATA 11.0 - 28 VDC, 10.0 - 28 VAC. Can use Elsema DC or AC power supply, 12PP1000 Supply Voltage or 24PP.
- Page 4 ™ Repeat steps 3 to 5 to program another multi-channel transmitter. If you are programming another transmitter, do not short out the CC pins. Shorting out the CC pins will delete all previously programmed transmitters. For detailed information visit www.elsema.com...
- Page 5 SINGLE CHANNEL PROGRAMMING This is used for programming one channel at a time to the transmitter. Single channel programming can be achieved by following the steps below: Step 1: receiver. Make sure all switches on the mode Connect power to the GIGALINK ™...
- Page 6 Suitable Antennas Suitable Power packs QM100 12PP-1000, 12V DC 1000mA ANT27 series (27MHz Series) or Quick Mount for easy mounting ANT433 series (433MHz Series) 24PP, 24V DC 500mA. of receivers on walls. For detailed information visit www.elsema.com...
- Page 7 MODE SETTING When the GIGALINK cable is disconnected the 4-way dipswitch functions as a mode selector for the output. User ™ should set the receiver mode correctly. See below table for different mode setting. Dipswitch Mode Settings The output relay will respond in the following manner when receiving the correct signal from a transmitter. 1 2 3 4 “All Momentary”: Relay on, only while correct signal is received “All Latching”: Outputs alternate at every correct incoming signal...
- Page 8 LED is flashing on the transmitter. Replace battery. CUSTOMER SUPPORT If your transmitter and receiver are still not operating properly, contact Elsema’s support office at: Phone: +61 (2) 9609 4668 Fax: +61 (2) 9725 2663 or you can visit our web site at www.elsema.com for the latest updates.
Need help?
Do you have a question about the Gigalink GLR43308 and is the answer not in the manual?
Questions and answers