Table of Contents
Advertisement
Behavior within the Z-Wave network
I
On factory default the device does not belong to any Z-Wave network. The device needs to join an
existing wireless network to communicate with the devices of this network. This process is called Inclusion.
Devices can also leave a network. This process is called Exclusion. Both processes are initiated by the
primary controller of the Z-Wave network. This controller will be turned into exclusion respective inclusion
mode. Please refer to your primary controllers manual on how to turn your controller into inclusion or
exclusion mode. Only if the primary controller is in inclusion or exclusion mode, this device can join or leave
the network. Leaving the network - i.e. being excluded - sets the device back to factory default.
If the device already belongs to a network, follow the exclusion process before including it in your network.
Otherwise inclusion of this device will fail. If the controller being included was a primary controller, it has to
be reset first.
Blinking red/green LED indicates that the device is in factory reset state. Once the controller is turned into
inclusion mode tripple click the button of the device or the push-button B located inside the housing
of the switch relay to include the device. A green blinking of LED will indicate successfull inclusion that
will be turned off shortly afterwards. The device is excluded by tripple click on one of the buttons when
the controller is in exclusion mode.
Operating the device
The switch insert is able to switch two different electrical loads. The actuator can directly be operated by a
local switching paddle. If the switch is a conventional button, every button impulse will connect the switch
ON or OFF. Using a switching paddle instead of a button the operation is the same with the exception that
(c) 2016 Z-Wave Europe GmbH, Antonstr. 3, 09337 Hohenstein-Ernstthal, Germany, All rights reserved, www.zwaveeurope.com - pp 5
Advertisement
Table of Contents
