Advertisement
714-630-7144
1. Lay your Kendon Stand Up™ Lift lying horizontally on the ground. Ensure
that it is fully retracted (e.g., ensure that the piston on the jack itself is fully
retracted – as with any air-over-hydraulic jack, it can appear to be fully
retracted, but can have a small amount of travel remaining). To do this,
simply push down on the Rail to confirm that the lift is fully lowered.
Unhook the rubber latch and fold out the rear section of the rail assembly.
2. Insert the loading ramp into the rear section of lift as shown below.
3. The ramp is now securely attached and extends out from the back of the
folding rear section of the lift.
4. Ensure the wheel chock on the rail is in the open position. The wheel
chock is in the open position when the wheel chock is rotated towards the
rear of the rail and the wheel chock channel will receive the front tire of
your motorcycle when it is loaded onto the rail.
- 12 -
www.KendonUSA.com
Advertisement
