Table of Contents
Advertisement
Value
w10, w5,
I0, I4
0, 0.0, 0.00
-199 ... 999
-199 ... 999
-199 ... 999
0 ... 999
0 ... 999
0 ... M
-199 ... 999
-199 ... 999
-199 ... 999
green, yellow, red
bAr, dot
coo, hEA
0 ... 999
0 ... 999
0 ... 999
0 ... 999
0 ... 999
-199 ... 999
FuL, L1, no
check the PV(100%) value when potentiometer slide is positioned at 100%. If PV(100%) value and
by the formula:
the bargraph pointer goes up within the Bargraph Low ... Bargraph High range, while in the opposite case,
Unit
w10 (0...10 V), w5 (0...5 V; potentiometer 0.5...10 kΩ),
-
I0 (0...20 mA), I4 (4...20 mA)
-
when indicating values with the input-signal measurement unit (ISU)
ISU
ISU
*
ISU
display offset value
ISU
used for input peak filtration; value '0' cancels the filtration
-
This parameter and the following one define a low-pass input filter.
ISU
M = 25% of input range
These parameters keep the set points in safe limits,
ISU
preserving them from random changes.
ISU
**
ISU
-
see 'Setting color'
'bar' - all LEDs underneath the pointer light together with it,
-
'dot' - only the pointer lights
-
'cooling' - activates over set point, 'heating' - activates under set point
ISU
less than (high range limit - Set Point 1)
ISU
less than (Set Point 1 - low range limit)
sec.
pulse duration; value '0' disables pulse mode
sec.
pause duration; value '0' disables pulse mode
sec.
Value '0' disables hold mode.
within operating range limits Input Low ... Input High, considering
ISU
SP Limit Low(High), Input Correction, and +/-Differential 1(2)
FuLL (full access), L1 (access only to parameters of level L1),
-
no (no access)
Notes
Table 1
Advertisement
Table of Contents
