Sony PP-A2780 Operating Instructions Manual page 33

Making calls when the headset is connected
When a headset (optional) is connected to the I
(HEADSET) jack on the cordless handset, you can
talk through the headset.
Making calls using the EZ Access function
To set up the access number, see "Setting up the EZ
Access function" on page 23.
1
Pick up the cordless handset from the charger.
2
Dial the phone number (e.g.,
1-201-123-4567, or 011-...).
3
Press (EZ ACCESS).
The system dials first, the access number set up
with the EZ access function, and then the phone
number you dialed in step 2. "TALK" appears
on the display.
4
When you're done talking, press (OFF) or
replace the cordless handset on the charger.
Note
If you have set up a phone number with the EZ access function, just press
(EZ ACCESS) to dial the phone number (i.e. skip step 2).
Additional tasks
To
Adjust the cordless
handset volume
Put a call on hold
Switch to tone dialing
temporarily
Switch to another call
("call waiting" service*)
* You need to subscribe to this service from your telephone company.
Do this
Set the VOL switch to H (high), M (middle) or L (low).
Press (HOLD). "HOLD" appears on the display.
Press (HOLD) again or pick up the cordless handset
from the charger (When Quick talk is set to "ON"; see
page 40) to resume the conversation.
Press (*TONE) after you're connected.
The line will remain in tone dialing until disconnected.
Press (CALL WAITING/FLASH).
Press (CALL WAITING/FLASH) again to return to the first
caller.
Open
TALK
E12011234567
NEW OLD MASSAGE RING OFF
continued
33 US
Basics