Additional Information; Troubleshooting - Sony DVP-NS700V Operating Instructions Manual

Additional Information

Troubleshooting

If you experience any of the following
difficulties while using the player, use this
troubleshooting guide to help remedy the
problem before requesting repairs. Should
any problem persist, consult your nearest
Sony dealer.
Power
The power is not turned on.
, Check that the AC power cord (mains lead) is
connected securely.
Picture
There is no picture.
, The connecting cords are not connected
securely.
, The connecting cords are damaged.
, The player is not connected to the correct TV
input jack (page 19).
, The video input on the TV is not correctly set.
Picture noise appears.
, The disc is dirty or flawed.
, If the picture output from your player goes
through your VCR to get to your TV, the copy-
protection signal applied to some DVD
programmes could affect picture quality. If
you still experience problems even when you
connect your player directly to your TV,
please try connecting your player to your TV's
S video input (page 19).
, If the colour system of your player does not
match with that of your TV, change the colour
system of the player. For details, see page 76.
(You cannot change the colour system of the
DVD disc itself.)
86
Even though you set the aspect ratio
in "TV TYPE" of "SCREEN SETUP,"
the picture does not fill the screen.
, The aspect ratio of the disc is fixed on your
DVD.
Sound
There is no sound.
, The connecting cord is not connected securely.
, The connecting cord is damaged.
, The player is connected to the wrong input
jack on the amplifier (receiver) (page 23, 25,
26).
, The amplifier (receiver) input is not correctly
set.
, The player is in pause mode or in Slow-motion
Play mode.
, The player is in fast forward or fast reverse
mode.
, If the audio signal does not come through the
DIGITAL OUT (OPTICAL or COAXIAL)
jack, check the audio settings (page 80).
, SACD audio signals are not output from the
digital jack.
, While playing a Super VCD on which the
audio track 2 is not recorded, no sound will
come out when you select "2:STEREO," "2:1/
L," or "2:2/R."
Sound is noisy.
, The disc is dirty or flawed.
Sound distortion occurs.
, Set "AUDIO ATT" in "AUDIO SETUP" to
"ON" (page 79).
The surround effect is difficult to hear
when you are playing a Dolby Digital,
DTS, or MPEG audio sound track.
, Check the speaker connections and setting
(page 23, 28, 80)