Monoprice Strata Home 38423 User Manual

Monoprice Strata Home 38423 User Manual

Cordless stick vacuum cleaner

Advertisement

Cordless Stick Vacuum Cleaner
P/N 38423
User's Manual

Advertisement

Table of Contents
loading

Summary of Contents for Monoprice Strata Home 38423

  • Page 1 Cordless Stick Vacuum Cleaner P/N 38423 User's Manual...
  • Page 2: Table Of Contents

    CONTENTS SAFETY WARNINGS AND GUIDELINES ............................3 CUSTOMER SERVICE ....................................4 PACKAGE CONTENTS ....................................4 PRODUCT OVERVIEW ....................................5 ASSEMBLY ..........................................6 USING THE WALL BRACKET .................................. 7 CHARGING ..........................................7 OPERATION .......................................... 8 USING AS A HAND VACUUM ................................8 CLEANING THE FILTER ....................................
  • Page 3: Safety Warnings And Guidelines

    SAFETY WARNINGS AND GUIDELINES Please read this entire manual before using this device, paying extra attention to these safety warnings and guidelines. Please keep this manual in a safe place for future reference.  This device is intended for indoor use only. It should be stored in a cool, dry place. ...
  • Page 4: Customer Service

    If you have any problem with your order, please give us an opportunity to make it right. You can contact a Monoprice Customer Service representative through the Live Chat link on our website www.monoprice.com or via email at support@monoprice.com.
  • Page 5: Product Overview

    PRODUCT OVERVIEW...
  • Page 6: Assembly

    ASSEMBLY 1. Attach the Battery/Handle to the Dust Cup. Ensure that the Battery Bolt Head is inserted into the Dust Cup Slot, as shown in the image below. 2. Insert the Metal Tube into the Dust Cup assembly until the lock clicks in place. 3.
  • Page 7: Using The Wall Bracket

    USING THE WALL BRACKET This vacuum includes a wall bracket for convenient storage when not in use. Perform the following steps to install the wall bracket. 1. Locate a section of wall with a nearby AC power outlet for convenient charging. Ensure that this location is not near heat sources and not in direct sunlight.
  • Page 8: Operation

    OPERATION Press the Switch to start the vacuum in low speed mode. Press it a second time to switch to high speed mode. Press it a third time to turn the vacuum off. USING AS A HAND VACUUM 1. Press the Metal Tube Lock on the Dust Cup assembly, then pull the Metal Tube out of the Dust Cup assembly.
  • Page 9: Cleaning The Filter

    CLEANING THE FILTER Perform the following steps to clean the filter. The filter should be cleaned after each use. 1. Press the Handle Lock to remove the Handle from the Dust Cup. 2. Twist counterclockwise to remove the Top Cover. 3.
  • Page 10 5. Fully dry the Filter and Filter Case. 6. Insert the Filter back into the Filter Case. 7. Insert the Filter Case into the Dust Cup. 8. Assemble the Top Cover onto the Dust Cup, then twist clockwise to secure it in place.
  • Page 11: Troubleshooting

    TROUBLESHOOTING Q1: The suction is weak. A1: Empty the Dust Cup. Ensure that the Dust Cup is installed correctly. Ensure that the Filter Case and the Filter are installed correctly. Clean the Filter. Q2: The vacuum won't power on. A2: Ensure that the Battery is charged. Thoroughly clean the Roller Brush and the Bearing. Q3: The Battery won't charge.
  • Page 12: Regulatory Compliance

    (2) this device must accept any interference received, including interference that may cause undesired operation. Modifying the equipment without Monoprice's authorization may result in the equipment no longer complying with FCC requirements for Class B digital devices. In that event, your right to use the equipment may be limited by FCC regulations, and you may be required to correct any interference to radio or television communications at your own expense.

Table of Contents