Specifications; Installation Instructions - Branick 7600 Installation, Operation & Repair Parts Information

 Before using this product, read and fully understand the operating
instructions and all decals on the product. This is necessary to
prevent injury to the operator and damage to the product.
 Do not attempt to use this product for anything other than its
intended purpose.
 Do not use this product if it is visibly worn, distorted or damaged.
 Always check condition of rubber hook pads on all six hooks before
using this tool. Replace if damaged or missing.
 Always wear appropriate eye protection.
 Inspect the spring of the strut assembly for any damage or
corrosion. Spring breakage during compression could cause injury.
 Failure to properly position the strut assembly in tool could result in
serious injury from sudden release of the strut assembly parts.

SPECIFICATIONS ___________________________________________________________

Max. Spring Compression Capacity ∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙ 3000 lbs (1361 kgs)
Min./Max. Spring Diameters ∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙ 3.5 / 11.5 in (9 / 29 cm)
Packaged Dimensional data ∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙ 18.5 x 20 x 43.63 in (47 x 51 x 111 cm)

INSTALLATION INSTRUCTIONS________________________________________________

1. Unpack and remove the unit from the shipping carton.
2. Inspect the unit for any visible damage.
3. Install on a solid vertical wall or post. (Can also be installed on an OPTIONAL benchmount or portable
cart)
4. Anchor the unit to the wall or post utilizing the two holes in the back plate. Make sure there is no
movement between the back plate and wall or post.
WARNING
Shipping Weight ∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙ 100 lbs (45 kgs)
CAUTION
2