Titan ZG 45PCI-HV Instructions Manual page 21

Stainless steel silencer unit with tuned length header
Tuned-Silencer #5770, mounted
on a ZG62 - it won't look much
different on the ZG 45PCI.
The coupling between the header and silencer, or tuned pipe, must withstand very high
temperatures. Silicone is useless for this purpose, but Teflon also will not withstand the
high temperature for a great length of time, meaning a constant checking and replacing
when required. This applies especially to silencers and tuned pipes integrated inside
a fuselage. A very robust alternative is the flexible steel tube #6581.
©2012 Toni Clark practical scale GmbH Zeiss-Str.10 D-32312 Lübbecke Tel. 0049 5741/5035 Fax. 05741/40338 www.toni-clark.com
Instructions Titan ZG 45PCI-HV
Tuned pipes are very long and
far from simple to install in a
model's fuselage. The stainless
steel silencer #5770 is a realistic
alternative. Including the header it
is only half the length and thereby
lighter. Originally developed for
the DA50, it will increase the power
of the ZG 45 by a good 20%. The
ideal header length is 22 cm, this is
measured along the centerline of
the header tube from the exhaust
gasket to the beginning of the
silencer inlet pipe stub.
The Tuned-Silencer #5770, close fitting header #5576,
Teflon tube #3896 and sprig clips #3899.
The drawing shows our standard
ready made headers for the ZG 45
and ZG 62. If none of them fit
your model, you can use the bent
tubing #6569, the flange #6571
and the special silver solder for
stainless material #0981 to make
yourself a perfect fitting header.
21