Sony ICD-TX800 Help Manual page 42

Help Guide
IC Recorder
ICD-TX800
Registering the remote control with the IC recorder
The remote control is already registered with your IC recorder at your purchase. However, you need to register it with the
IC recorder once again in certain cases. For example, when the remote control is returned from the repair service, follow
the steps below to make device registration.
Make sure that the IC recorder is turned off. On the IC recorder, press and hold
1
the HOLD•POWER switch to "POWER" and hold it for 8 seconds or longer.
When the display window of the IC recorder turns off, keep holding
HOLD•POWER switch. This restarts the remote control.
When "Power On" appears on the display window of the IC recorder, take your finger off
2
"Press Any Button on the Remote Control" appears on the display window of the IC recorder.
Press the RESET button on the back of the remote control, and then press any button on the remote
3
control.
The operation indicator on the remote control flashes alternately in red and blue and the device registration process
starts.
When the device registration process completes, "Remote Control Registered" appears on the display window of
the IC recorder.
Note
While the device registration process is in progress, button operations on the remote control are unavailable. Wait until the
operation indicator stops flashing, and then operate the remote control.
If the remote control does not work, make sure that the remote control is released from the HOLD state.
STOP and take your finger off the
42
STOP ( ), and then slide
STOP.