Set Up - Pace ARM-EVAC 150 Operation Manual

Set up

1. The Arm-Evac 150 has been designed for ease of use and maximum installation flexibility in mind. The
major considerations for placement of the unit are:
2. Remove Arm-Evac 150 from packaging and place in suitable position.
3. Open the Arm Evac 150 Central Filtration Unit by unlatching the Lid Clasps. The General-Purpose
Combo Filter P/N 8883-0932-P1 (includes Pre-Filter P/N 8883-0112-P5) is preinstalled – simply verify
the Filter is directly in the middle, and in the correct position. Then re-latch the Lid Clasps.
4. Push the brake lever down on the 2 opposing Locking Casters to prevent the unit from rolling.
5. Install the Flex Arm by attaching the flange to one of the Air Inlets on the top of the Central Filtration
Unit. After the Arm is secure, attach the Nozzle to the front of the Flex Arm – it should snap on easily.
6. Plug the supplied power cord into receptacle at left side of unit, ensuring that it is connected to a
properly grounded outlet. The Arm-Evac 150 will plug into a standard 110VAC or 230VAC electrical
outlet depending on which version you have. The appropriate power cord is provided with each system.
7. Turn on the Arm-Evac 150 using the main power switch at the side of the unit.
©2018 PACE Inc., Vass, North Carolina. All Rights Reserved
Exhaust Vents: Located on both sides of the unit (see image on left). When
positioning the unit, make sure airflow to exhaust vents are not blocked/restricted.
Proximity to work area: The unit should be placed as close to the work area as is
convenient. Do not create sharp bends in the Flex Arm, as this reduces airflow.
Unit Location: The unit should be located so that it will not block aisleways or
impede traffic of material handling pathways. It is important to position the unit in a
way that allows clearance to remove the lid and replace the filter when needed.
www.paceworldwide.com Page 4