Grinding - Baumr-AG SH0910 User Manual

Chainsaw Sharpener

Grinding

Before the start of grinding, the chain should be conducted between both the attachment guides.
The sharpening angle must correspond to the guide's position.
The type of chain to be sharpened can be determined using the sharpening block provided on
the dimension table.
Loosen the mounting screw (10b) and place the cutting chain in the guide rail between the guide
plate (Fig. 11).
Fold the chain stop (Fig.12) down and pull the chain toward the back until the cutting link rests
against the stop.
Set the top plate angle by means of the set screw (P.2, P.4); you can also use the scale to set
the angle. The vice angle should be setup by the set screw.