Sony SDZ-S100 Operating Instructions Manual page 28

28
Chapter 2 Installation
When the SDZ-S100 is one of several devices on the SCSI
bus
1
Turn off all SCSI devices on the SCSI bus, including the SDZ-S100.
Caution
When connecting or disconnecting a SCSI cable to SCSI devices
(including the SDZ-S100), turn off all the SCSI devices. Failing to do so
may result in damage.
2
Connect the SCSI cable to the next device on the SCSI bus, connect the
terminator to the last device on the bus, then issue the host command to
resume operation.
SCSI
connector
Host computer
Notes
• The total length of the SCSI cables between the host computer and the last
device should be less than 12 m (39.4 ft.). (The SDZ-S100 internal cable
length is 25 cm (9.8 in.).)
• If the SDZ-S100 is the last device on the SCSI bus, make sure that you connect
the terminator to the open connector.
When you are done, proceed to "Configuring the S-AIT Tape Drive Unit to the
Host" on page 30.
SCSI devices
Terminator
SCSI cable