Troubleshooting; Maintenance; Technical Specification; Product Disposal Information - miniland warmy advanced Manual

ENGLISH
NOTE 1: During the sterilization process if there is not enough
water to complete the process, you will hear 5 beeps and the
display will flash in red, showing the water icon.
Please put 40ml of tap water into the heating chamber (add water up to the line in
the heating chamber) and press the MODE button once. The device will
automatically continue the process with the remaining time.

5.4. TROUBLESHOOTING

SYMPTOMS
1. The display is off
2. The screen is RED
and flashing with the
water symbol ( )
3. Other malfunctions

6 MAINTENANCE

Please follow the instructions below:
· On the device (main body):
Always turn OFF and unplug before cleaning. Use a damp dishcloth to clean it.
· On the device (warming chamber):
According to the quality of the water used, over time a limescale deposit can build
up on the bottom of the heating chamber. You should regularly descale your bottle
warmer by pouring a mixture of 100 ml of hot water + 100 ml of white vinegar into
the heating chamber.
Leave this to act for approximately 30 minutes before emptying the chamber and
wipe with a damp cloth. Do not use detergent to clean the unit.
· Detachable accessories:
The plastic parts are dishwasher safe, however it is highly recommended to wash
by hand.

7 TECHNICAL SPECIFICATION

· CAR: voltage: 12VDC; consumption: 100W.
· HOME: voltage: 220-240VAC; frequency: 50 - 60Hz; consumption: 320W.

8 PRODUCT DISPOSAL INFORMATION

· Remember to dispose of the product responsibly.
· Do not mix products bearing the crossed -out bin symbol with your
general household waste.
· For the correct collection and treatment of these products take them
to the collection points designated by your local authority.
Alternatively contact the retailer who sold you the product.
POSSIBLE CAUSE AND THINGS TO DO/CHECK
Please be sure you have plugged the device and
pressed ON button.
There is not enough water. Please put 40ml of tap water
into the heating chamber (add water up to the line in the
heating chamber) and press the MODE button.
Please contact the MINILAND technical service.
01:13
m:s