Table of Contents
Advertisement
DRAFT DGA-LT1 Installation Guide
Canadian Compliance Statement
This device contains license‐exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada license‐exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the
device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation,
Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes :
(1) L'appareil ne doit pas produire de brouillage;
(2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
NOTE: Afin d'assurer la conformité aux exigences de la FCC en matière d'exposition aux radiofréquences, aucune
modification de l'antenne ou de l'appareil n'est autorisée. Toute modification de l'antenne ou de l'appareil
pourrait avoir pour conséquence que l'appareil dépasse les exigences en matière d'exposition aux radiofréquences
et annule le droit de l'utilisateur de faire fonctionner l'appareil
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause interference
(2) This device must accept interference, including interference that may cause undesired operation of the device.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These Limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the users is encouraged to try to correct the interference by one or more of the following measures.
‐ Reorient or relocate the receiving antenna
‐ Increase the separation between the equipment and the receiver
‐ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
‐ Consult the dealer or an experienced radio/TV technician for help
Any changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
8
Advertisement
Table of Contents
