Canyon/Colorado Programming; Vehicle Application Guide - Directed Electronics 556L Manual

C C A A N N Y Y O O N N / / C C O O L L O O R R A A D D O O P P r r o o g g r r a a m m m m i i n n g g
The module must be programmed before first operation, use the
following procedure:
I I M M P P O O R R T T A A N N T T ! ! The vehicle must be started within 15
seconds or the module will automatically exit the learn
routine.
1. Cycle the ignition On/Off four times (1/2 to 1 second).
2. On the 5 th time crank the engine and hold in that position.
V V e e h h i i c c l l e e A A p p p p l l i i c c a a t t i i o o n n G G u u i i d d e e
Refer to vehicle specific information on DirectWire or refer to doc-
ument 1059.
© 2005 Directed Electronics, Inc. Vista, CA
N556L 05-05
3. There will be a series of 4 flashes, continue to hold in the
crank position for 10-20 seconds until a 5
obtained.
4. The R code is now learned, turn the engine off and remove the
ignition key.
5. Programming is now complete. Test the remote start at least
twice.
th quick flash is
5 5