Maintenance; Warranty - Whale RT3000 Installation And Operation Manual

2. If necessary, rotate the lid attached to the holder so the screw holes align and the lid opens
vertically downwards.
3. Position the holder in the hole and use as a template to mark the position of the 3 fixing screw
holes.
4. Drill 3 x 2.8mm holes.
5. Secure the holder with the lid attached using the 3 screws provided. Ensure they are screwed in
flush with the holder flange.
6.2 Assembly
1. Place a large washer into ferrule on hose assembly and tighten into shower handset (See Fig 3)
2. Feed the unattached end of the hose through the large open end of the handset holder.
3. When in operation, it is possible for a small amount of water to trickle along the shower hose
therefore check that there is no possibility of drips damaging electrical equipment, furnishings or
contents of lockers.
6.3 Plumbing
1. Connect the existing system pipe work and attach the appropriate water supply (Cold Only).
2. Attach the free end of the handset hose to the water supply using a suitable ½" or ⅜" BSP
connection (supplied with shower).
7. INSTRUCTIONS FOR USE
1. The shower handset is extracted by grasping it, twisting slightly and pulling it out of the holder.
2. Press trigger for on/off control, or flick trigger up for constant flow.
3. After use, replace the handset in the holder. Push firmly into place ensuring the trigger fits neatly
into the hole at the back of the holder. Replace the lid.
NOTE. Ensure the trigger is not accidently pressed down upon stowage
8.

MAINTENANCE

This Whale® Swim N Rinse Compact Shower is designed to only require minimal maintenance.
WARNING: Before servicing, turn off and drain water from system.
Optimal Performance
• Regularly inspect the shower unit to ensure optimal preformance
9. WINTERIZING
Freezing in winter may cause damage to the Whale® Swim N Rinse Compact Shower. To avoid this damage,
ensure the system is completely drained.
1. Drain the fresh water tank either using the pump or a drain valve.
2. Turn pump on and open all faucets (including drain valve), allow the pump to purge the water from the system.
3. Open the Whale® Swim N Rinse Compact Shower until water flow stops.
4. Turn off Whale® Swim N Rinse Compact Shower.
5. Turn off power isolator switch for water pump.
6. Remember to leave all outlets open (except Whale® Swim N Rinse Compact Shower) to avoid any damage.
10. SERVICE SUPPORT DETAILS
For installation or service advice please contact Whale® customer support:
Tel: +44 (0)28 9127 0531
Email: info@whalepumps.com
11. EU DECLARATION OF CONFORMITY, STANDARDS, APPROVALS
This product complies with all relevant European directives and standards. Please contact Whale® if further details
are required
12. PATENTS/ TRADEMARKS
Whale®, is a registered trademark of Munster Simms Engineering Limited, Bangor Northern Ireland trading as
Whale®.
13.

WARRANTY

This Whale® product is covered by a 1 year warranty.
Please see the enclosed document for details of our statement of limited warranty.
©Copyright Whale® 2016 - All rights reserved.
WHALE®, is a registered trademark of Munster Simms Engineering Limited, Bangor, Northern Ireland trading as
Whale®. Whale's® policy is one of continuous improvement and we reserve the right to change specifications
without prior notice. Illustrations are for guidance purposes only.
USA Tel: 1 616 897 9241
Email USA: usasales@whalepumps.com