Aiwa NSX-D7 Operating Instructions Manual page 28

VIDEO/AUX
MD
LINEOUT
SURROUND
SPEAKERS
CD DIGITALOUT
(OPTICAL)
- -=
=4 - . .
Refer to the operating instructions of the connected equipment
for details.
The connecting cords are not supplied. Obtain the necessary
connecting cords.
Consult your local Aiwa dealer for optional equipment.
This unit can input analog sound signals through these jacks.
Use a cable with RCA phono plugs to connect audio equipment
(turntables, LD players, VCRs, TV, MD players etc.).
Connect the red plug to R jack, and the white plug to L jack.
When connecting a turntable
Use an Aiwa turntable equipped with a built-in equalizer amplifier.
This jack is recommended to connect with an MD player.
Use a cable with RCA phono plugs.
Connect the red plug to the MD R jack, and the white plug to the
MD L jack.
When MD player is connected to these jacks, no sound will be
output from the LINE OUT jacks.
This unit can output analog sound signal through these jacks.
Use a cable with RCA phono plugs to connect audio equipment
with LINE IN (analog input) jacks.
Connect the red plug to LINE OUT R jack and the white plug to
LINE OUT L jack.
Do not connect an equipment to LINE OUT and VIDEO/AUX
simultaneously. Otherwise, noise is generated and malfunction
occurs.
Connect optional surround speakers with the 8 ohms to 16 ohms
impedance to the jacks.
CD DIGITAL OUT (OPTICAL) JACK
This unit can output CD digital sound signals through this jack.
Use an optical cable to connect digital audio equipment (DAT
deck, MD recorder, etc.).
Remove the dust cap @ from the CD DIGITAL OUT (OPTICAL)
jack. Then, connect an optical cable plug to the CD DIGITAL
OUT (OPTICAL) jack.
When the CD DIGITAL OUT (OPTICAL) jack is not being
used
Attach the supplied dust cap.
To play equipment connected to VIDEO/AUX jacks or MD jacks,
proceed as follows.
1
Press VIDEO/AUX or
MD.
To play the equipment connected to VIDEO/AUX, press
VIDEO/AUX. "VIDEO appears on the display.
To play the equipment connected to MD, press MD. "MD"
appears on the display.
2 Play the connected equipment.
To change a source name in the display
When VIDEO/AUX is pressed, "VIDEO is displayed initially. It
can be changed to "AUX or "TV.
With the power on, press POWER while pressing VIDEO/AUX.
Repeat the procedure to select one of the names.
To adjust the sound level of the external source
When the sound level of the external source is much higher or
much lower than that of other function sources, adjust it as
follows.
1 Press VIDEO/AUX or MD and play the equipment.
2 Press < or *so that the sound level becomes the same
as that of other function sources.
m
During recording, the sound level cannot be adjusted.
27
ENGLISH