Unloading; Unloading The Maintenance Bypass Cabinet - Vertiv Liebert Maintenance Bypass Cabinet Installer/User Manual

6 UNLOADING

The unit frame is bolted to the shipping pallet to ensure safety. We recommend using a pallet jack to
transport the unit to its operating location prior to unbolting the unit.

6.1 Unloading the Maintenance Bypass Cabinet

CAUTION: This Maintenance Bypass Cabinet is heavy (see weight in Table 5.1 on page 15). At
least two people should assist to unload it from the pallet.
1. Once the Maintenance Bypass Cabinet is near the desired operating location, remove the
cardboard cover.
2. Use a 1/2" (13mm) wrench to remove the eight
mounting bolts (four per bracket) from the pallet
brackets. Remove mounting brackets from the
pallet and Maintenance Bypass Cabinet. Keep
brackets and bolts for future transportation of the
cabinet or for securing the cabinet to the floor.
3. Remove the metal ramp from the bottom of the
pallet, rotating it 180°. Fit ramp onto opposite side
of pallet (in slot) as shown below.
4. Using two people, slowly roll the cabinet down the ramp until the unit is on a level surface (see
below, left).
5. Once the cabinet is in the desired location, adjust the leveling feet to secure its position (see
below, right).
Vertiv | Liebert® Maintenance Bypass Cabinet Installer/User Guide | 17