Bimba Ultran Repair Instructions

CAUTION!
The magnets used in the Ultran product line are of an extremely high strength and brittle material.
Caution should be used in handling these magnets.
If the magnets are cracked due to impact fractures during the repair process, they will repel each other
and fly apart.
During the repair of the product, be sure your fingers do not get between the piston and the carriage.
The magnets on both these parts will attract each other and could cause injury.

NOTES

Cleanliness of the internal parts is imperative for maximum life of the slide unit.
Parts that have been repaired should be covered or bagged until needed for finished assembly.
Any high grade of bearing grease should be used for lubrication purposes.
Tools required:
> knife or wire cutters
> hex driver
> arbor press
> screwdriver
> retaining ring pliers
> torque wrench
> plastic bags or clean containers to hold parts during the repair lubricant
NOTE on Arbor Press: Using an arbor press is the safest and preferred way to perform some of the operations
in these instructions. Pressing through the body's length is necessary, so the arbor press must have its table
a distance from the floor that is equal to or greater than the stroke of the cylinder. A proper repair is unlikely if
these warnings are not followed.
Ultran Slide Rodless Cylinder
®
Product Instructions
Repair Instructions
1