Advertisement
CARRIAGE RELEASE LEVERS
WITH CARRIAGE AT EXTREME RIGHT MARGIN, LOOSEN CARRIAGE RELEASE LEVER SCREW RIGHT
H-20-5119.
OPERATE CARRIAGE RELEASE LEVER RIGHT UNTIL LUG ON LEVER IS AGAINST POST
ON RIGHT CARRIAGE END.
MOVE FEED RACK H- 20-7367 TO REAR UNTIL IT IS FREE OF PINION
WHEEL.
TIGHTEN CARRIAGE RELEASE LEVER SCREW H-20-51 19.
WITH CARRIAGE AT EXTREME LEFT MARGIN, LOOSEN CARRIAGE RELEASE LEVER SCREW LEFT NUT
H-20-5345.
ADJUST CARRIAGE RELEASE LEVER SCREW LEFT H-20-5297
IN UNTIL IT TOUCHES
LEFT CARRIAGE END.
BACK OUT ON SCREW SO IT WILL JUST CLEAR LEFT CARRIAGE END.
(this adjustment removes END PLAY FROM RELEASE MECHANISM.)
ADJUST LEFT CARRIAGE
RELEASE LEVER SAME AS RIGHT.
TIGHTEN CARRIAGE RELEASE LEVER SCREW NUT H-20-5345.
ALIGNING SCALE
ADJUST ALIGNING SCALE H-20-7193 TO BE LEVEL AND HAVE TOP OF SCALE JUST BELOW BOTTOM
OF PRINTED LINE.
FORM BRACKET SO 6 SHEETS OF PAPER CAN BE INSERTED BETWEEN SCALE AND
PLATEN.
CARRIAGE
REMOVAL COMPLETE WITH BED RAIL
NOTE:
SOME MACHINES HAVE SHIMS H-20-7206 BETWEEN CARRIAGE FRONT RAIL H- 20-7210
AND FRAME.
SHIMS MUST BE REPLACED OR MOTION AND IMPRESSION WILL BE DIFFI
CULT TO OBTAIN .
UNHOOK DRAW CORD H-20-5890.
REMOVE 4 ESCAPEMENT ROCKER BRACKET MOUNTING SCREWS
H-20-5119 AND WASHERS H- 20- 5 401 .
REMOVE 4 CARRIAGE FRONT RAIL MOUNTING SCREWS
H-20-5102.
REMOVE ALIGNING SCALE H-20-7193.
CARRIAGE CAN NOW BE REMOVED FROM FRAME.
REPLACEMENT COMPLETE WITH BED RAILS
WHEN SETTING CARRIAGE ON FRAME, MAKE SURE UPPER END OF BACK SPACE INTERMEDIATE
LEVER SPRING H-20-5711 IS AGAINST CARRIAGE FRONT RAIL AND TO THE LEFT OF ITS MOUNTING
SCREW H-20-5233.
SEAT CARRIAGE FRONT RAIL ON CARRIAGE RAIL PINS H-20-5533.
INSTALL
SHIMS H-20-7206 IF NEEDED.
INSTALL 4 CARRIAGE FRONT RAIL MOUNTING SCREWS H-20-5102.
CARRIAGE IS NOW AT ITS ORIGINAL POSITION.
SEAT ESCAPEMENT BRACKET AND INSTALL
MOUNTING SCREWS.
REMOVAL OF CARRIAGE FROM BED RAIL
REMOVE CARRIAGE COMPLETE AS ABOVE.
REMOVE KEEPER H-20-5435 FROM ONE END OF CARRIAGE
RACK H-20-7848.
REMOVE CARRIAGE RACK.
CARRIAGE CAN NOW BE REMOVED FROM BED RAIL.
INSTALL CARRIAGE IN BED RAIL
SLIDE CARRIAGE INTO BED RAIL.
POSITION CARRIAGE SO GEAR OF CARRIAGE BALL RETAINER
H-20-7845 IS IN THE LAST TOOTH OF CARRIAGE BALL RETAINER RACK H-20-7186.
HOLD
CARRIAGE IN THIS POSITION.
INSTALL CARRIAGE RACK H-20-7848.
REPLACE CARRIAGE RACK
KEEPERS H-20-5435.
CARRIAGE REAR RAIL ADJUSTMENT
LOOSEN AND MAKE FRICTION TIGHT 4 CARRIAGE REAR RAIL MOUNTING SCREWS H-20-5281.
Advertisement
