Advertisement
Available are over 8,000 different programmable settings which are available in either receiver.
Questions on programming should be directed to Technical Support @ 888-392-2007 x 1751.
NOTE: If the receiver sounds a solid tone and
the light stays on this means that the code is not
compatible with the receiver and will not be
successfully transmitted to the receiver.
4. After reprogramming is complete the transmitter
returns to normal operation mode. You can also
return to normal operation by unplugging the power
cord, waiting 5 seconds, and then reinserting the
power cord. Alternatively, do nothing for two
minutes and the transmitter will return to normal
operation.
How to Confirm Receiver Settings
Step 1 – Set the Transmitter to Programming Mode
-
Remove the power cord from the Transmitter.
-
While pressing the top and bottom buttons down replace
the power plug.
You're now in programming mode with the display
-
showing "10".
Step 2 – Select the Confirmation Function
Press on the top button to advance the function to "90"
-
-
Then press the bottom button.
Step 3 – Confirm the settings of the Receiver.
-
Hold the Receiver over the Transmitter, press the
bottom button again.
The "99" begins to flash and the Receiver's battery light
-
will come on. You are now ready to read the program of
the Receiver.
-
Press the bottom button once again - the Transmitter
then tells the Receiver to reveal its current settings.
The Receiver will beep and the battery light will blink
in a pattern that corresponds with the Receiver's
current settings. The Receiver will beep for the
function and flash for the setting.
For example, a setting of 7K will beep once indicating
"Function 10" followed by three blinks indicating
"Setting 13", and a setting of a 3-Second
Progressive Duration will beep four times indicating
"Function 40" followed by four blinks which indicates
"Setting 44".
©2008 Perimeter Technologies, Inc.
Underground Dog Fence
Pet Stop of North Georgia, LLC
Programming Guide – OT-200
2
Advertisement
