Gentlesteps Programming / Adjustment; Sensitivity Adjustment - Pet Stop OT-300 Programming Manual

For pet stop ecolite

Hide thumbs Also See for OT-300:

GentleSteps™ Programming / Adjustment

Step 1 – Press and hold the center button until the display flashes and reads "98"

then release the button.

(The Transmitter is now in Programming Mode)

Step 2 – With the display flashing the number "98" place the receiver to within 2 –

6 inches of the transmitter. When the receiver is in place the low battery light will

activate.

Step 3 – While the receiver's low battery light activated use the up or down

buttons to advance or decrease the setting. The receiver will beep twice and the

low battery light will blink a specific number of times to correspond to the

selected setting. If this is the setting you desire then press the center button to

set the level.

(For example if training level 5 is selected the receiver will blink 5 times)

Note: You can only advance or decrease the setting one level at a time. After

making an adjustment the display will stop blinking for 2 seconds and then begin

to blink again. Once the display begins to blink another adjustment can be made.

Step 1 – Press and hold the center button until the display flashes and reads "97"

(The display will flash and first show "98". Continuing holding down the button

until the display advances to the number "97")

Step 2 – With the display flashing the number "97" place the receiver to within 2 –

6 inches of the transmitter. When the receiver is in place the low battery light will

activate.

Step 3 – While the receiver's low battery light activated use the up or down

buttons to advance or decrease the setting. The receiver will beep twice and the

low battery light will blink a specific number of times that corresponds to the

selected setting. If this is the setting you desire then press the center button to

set the level.

Note: You can only advance or decrease the setting one level at a time. After

making an adjustment the display will stop blinking for 2 seconds and then begin

to blink again. Once the display begins to blink another adjustment can be made.

Programming Guide V4.1 OT-300

Mini Receiver Code

Page 3 of 5