Advertisement
Programming Instructions
Signal Field Adjustment
Step 1 – Press and hold the center button until the display begins to flash and then
release the button. You will see periods after each number
Step 2 – Using the up or down buttons, scroll through to the desired setting and
then use the center button to enter your selection. The number in the display will
flash once confirming your setting. After 20 seconds the transmitter will return to
normal operation with your new setting.
All Functions (except Sensitivity and GentleSteps™)
Step 1 – Select The Settings to Program
a) Press and hold both up and down buttons until the display reads "10"
(The Transmitter is now in Programming Mode)
b) Use the enter button (the center button) to enter the series to be modified
c) Using either the up and down buttons, scroll through the menu and then use
the center button to modify any setting you desire.
will automatically advance to the next setting option)
You can choose to skip over any series by pressing the either the top or bottom
button when not inside a series
Step 2 – Confirm the Settings to be Programmed
After making your selection advance to function '90'. You can view all the
settings by pressing the center button and then scrolling through the selections
using either the top or bottom button. No programming is occurring at this stage.
Step 3 – Program The Receiver
1.
While the receiver over the small loop, press the center button. The display
will show '99'9 and begin to flash. At this point the receiver light will come on
indication that the receiver is ready to receive programming. Note: Should
the receiver sound a solid tone it means that the receiver did not detect
signal correctly. When the tone stops, repeat step 1.
2.
Press the center button again. '99 stops flashing and the code begin to
transmit to the receiver. While this is occurring, the receiver will begin to
beep and the light flash in a pattern corresponding with your selections. For
example, a setting of 7K will beep once followed by three flashes.
3.
Once programming is complete the transmitter returns to '99' and is ready to
program another receiver. To return the transmitter to normal operation,
press and hold the bottom button for 3 seconds or simply unplug the
transmitter for 5 seconds. Alternatively, by doing nothing the transmitter will
return to normal operation after 20 seconds.
Programming Guide V4.1 OT-300
Mini Receiver Code
(Once modified the display
Page 2 of 5
©20101Perimeter Technologies, Inc
Advertisement
