Shorthand Instructions - Sentry Xpress 5.0 Instructions For Use Manual

Sentry Xpress Cone-Fire Shorthand Programming
After you press the key(s) in the left column, the message in the center will appear.
KEYS TO PRESS
Apply power to kiln
Start/Stop, Up Arrow (NOT down)
Start/Stop, Up & Down Arrows
Start/Stop
Up & Down Arrows
Start/Stop
Up & Down Arrows
Start/Stop
Up & Down Arrows
Start/Stop
Up & Down Arrows
Start/Stop
Start/Stop
Up & Down Arrows
Start/Stop
The kiln is now firing to the cone you selected.
*The COOL, LOCK, and DELA prompts appear only after they have been turned on in Options. To turn
them on or off, see Cool, page 17, Lock, page 21, or DELA, page 17. This takes only seconds.
36
DISPLAY
IDLE
CONE
05
SPD
FAST
HOLD
00.20
COOL
0200
LOCK
0000
STRT
DELA
00.00
-ON-
Do not leave your kiln unattended during operation.
COMMENTS
Press Start/Stop if IDLE doesn't appear.
.
Select CONE
Select cone number.
Ready to select a firing speed.
Select FAST, STD, or SLOW.
Ready to enter a hold time.
Sample. Enter hold (hrs.mins)
Ready to enter a cooling rate.*
Sample cooling rate.
Do you want to lock program?*
Enter passcode to lock program.
Kiln is ready to fire.
Do you want to delay the firing?*
Enter delay time. 00.00 = no delay
The kiln is now firing.