Shorthand Instructions - Sentry Xpress 5.0 Instructions For Use Manual

Sentry Xpress Ramp-Hold Shorthand Programming
After you press the key(s) in the left column, the message in the center will appear.
KEYS TO PRESS
Apply power to kiln
Start/Stop, Up Arrow (NOT down)
Start/Stop, Up & Down Arrows
Start/Stop
Up & Down Arrows
Start/Stop
Up & Down Arrows
Start/Stop
Up & Down Arrows
Start/Stop
Up & Down Arrows
Repeat for other segments. Enter a rate of 0 for 1st segment not needed.
Start/Stop
Up & Down Arrows
Start/Stop
Start/Stop
Up & Down Arrows
Start/Stop
*The LOCK and DELA prompts appear only after they have been turned on in Options. To turn them on
or off, see Lock, page 21, or DELA, page 17. This takes only seconds.
DISPLAY
IDLE
USER
PR01
UNLO
0000
RA 1
0000
°F
0200
HD
00.00
LOCK
0000
STRT
DELA
00.00
-ON-
The kiln is now firing.
Keep the kiln lid or door closed when the kiln is not in use.
COMMENTS
Press Start/Stop if IDLE doesn't appear.
Select USER.
Select desired program number (1-25).
Program is locked.*
Enter passcode to unlock.
Ready to enter a firing rate.
Enter rate.
1
Ready to enter a firing temperature.
Sample firing rate.
1
Ready to enter a hold time, if any.
Enter hold time. 00.00 = no hold time.
Do you want to lock the program?*
Enter passcode. 0000 = leave unlocked.
The kiln is ready to fire.
Do you want to delay the firing?
Enter delay time. 00.00 = no delay.
The kiln will begin firing in 30 seconds.
35