Rockwell ShopSeries RS8137 Manual

2400psi petrol high pressure washer

Advertisement

2400PSI PETROL HIGH PRESSURE WASHER
EN
RS8137

Advertisement

Table of Contents
loading

Summary of Contents for Rockwell ShopSeries RS8137

  • Page 1 2400PSI PETROL HIGH PRESSURE WASHER RS8137...
  • Page 3 RS8137...
  • Page 4 RS8137...
  • Page 5 RS8137...
  • Page 6 RS8137 0.75mm...
  • Page 7: Component List

    2400PSI PETROL HIGH PRESSURE WASHER COMPONENT LIST TRANSPORTION HANDLE STORAGE FOR TRGGER GUN AND LANCE STORAGE FOR NOZZLES STORAGE FOR START HANDLE STORAGE FOR HIGH PRESSURE HOSE RECOIL STARTER HANDLE FUEL TANK CAP AIR FITER CASE SPARK PLUG CONNECTOR IGNITION SWITCH CHOKE LEVER WATER OUTLET PUMP(SELF PRIMING PUMP)
  • Page 8: General Power Tool Safety Warnings

    2400PSI PETROL HIGH PRESSURE WASHER ACCESSORIES ADDITIONAL POWER TOOL SAFETY WARNINGS Spark plug socket spanner Pressure lance - WARNING: Do not use the Pressure nozzle (0°/15°/45°) appliance without reading the Trigger gun Pressure hose instruction sheet. - Safety boots, safety gloves, safety Use good quality accessories marked with a well- helmets with visors, hearing known brand name.
  • Page 9 2400PSI PETROL HIGH PRESSURE WASHER - WARNING Risk of explosion – Do make sure that the flue gases are not spray flammable liquids. properly discharged. - WARNING To ensure machine - WARNING Always switch off the safety, use only original spare mains disconnecting switch when parts from the manufacturer or leaving the machine unattended.
  • Page 10: Technical Data

    2400PSI PETROL HIGH PRESSURE WASHER SYMBOLS Do not smoke in the work area, around the product and in the vicinity of flammable materials! Machine not suitable for connection to Read the manual potable water mains Wear hearing protection RCM marking ABN: Australian Business Number.
  • Page 11 2400PSI PETROL HIGH PRESSURE WASHER OPERATING INSTRUCTIONS the oil is changed after the first 5 hours of use - refer to “Maintenance”. NOTE: Before using the tool, read the instruction book carefully. 2) FILLING WITH ENGINE OIL (See Fig. B1&B2) CAUTION! To prevent engine damage the 1.
  • Page 12: Operation

    2400PSI PETROL HIGH PRESSURE WASHER or where petrol is stored. Avoid repeated or performed all of the following. prolonged contact with skin or breathing of vapor. 1) Be sure to read Operation sections before using NOTE: Petrol should be stores in an approved pressure washer.
  • Page 13: Maintenance Schedule

    2400PSI PETROL HIGH PRESSURE WASHER WARNING: DO NOT ATTEMPT TO USE to 61 cm away from cleaning surface. 8) If you get nozzle too close, especially using a high CLEANER WITHOUT THE LANCE OR ANY pressure nozzle, you may damage surface being ACCESSORIES ATTACHED cleaned.
  • Page 14: Engine Maintenance

    2400PSI PETROL HIGH PRESSURE WASHER materials, such as dirt, etc. To correct the problem, 4) Tighten the oil drain screw and refill the oil tank immediately clean the spray nozzle following these with SAE30 engine oil. instructions: 5) Start the engine and allow it run briefly. Stop the 1) Switch engine off and turn off water supply engine, wait one minute and check the oil level.
  • Page 15: Troubleshooting

    2400PSI PETROL HIGH PRESSURE WASHER TROUBLE SHOOTING Please check the following before contacting the service organization: Problem Cause Correction 1. Low pressure spray tip 1. Replace with high pressure spray tip. installed. 2. Clear inlet. Pump has following 2. Water inlet is blocked. 3.
  • Page 16 MADE IN PRC...

Table of Contents