Advertisement
GX630 • GX660 • GX690 Technical Manual
E
VAPORATIVE EMISSIONS
The OEM is responsible for meeting the CARB EVAP emissions regulations for products sold in California. This
regulation concerns evaporative emissions from the fuel system. See the Emission Regulation Guide for additional
details.
Shown below is a simplified overview of required components.
AIR OR EXHAUST GAS
FUEL VAPOR
CHARGE TUBE (BREATHER)
The charge tube should be
located as high as possible in
the fuel tank. Fuel should not
flow through the charge tube
during regular use or during
transportation
CARBON CANISTER
Install the carbon canister so
that the intake port will not be
affected by the dynamic
pressure of cooling air.
Additional information regarding manufacturers of CARB certified fuel system components can be found at:
http://www.arb.ca.gov/msprog/offroad/sore/sorecomponent/sorecomponent.htm#.
BANJO CORPORATION
A Unit of IDEX Corporation
150 Banjo Drive
Crawfordsville, IN 47933 U.S.A.
© 2009 American Honda Motor Co., Inc — All Rights Reserved
Telephone: (765) 362-7367
Tech Sales: (888) 705-7020
Fax: (765) 362-0744
banjocorp.com
(CARB T
3)
IER
FUEL VALVE
PURGE TUBE
Maximum length: 80 cm.
PURGE JOINT
Connect the purge tube to the joint on
the dirty side of the air cleaner.
Joint outer diameter: 11 mm
Please see banjocorp.com for more information
FUEL CAP (SEALED)
(must be tethered and have positive
feedback mechanism for closure.)
FUEL TUBE
Use approved low permeation
fuel tube between the filter
and the fuel tank.
FUEL FILTER
© Copyright 2018 Banjo Corporation. All Rights Reserved.
BJO_MAN_KK-83_222_333_444_PolyPumpManual_Rev0918
31
Advertisement
