Sony CDX-L450X Operating Instructions (English, Español) Installation/Connections page 2

4 A
(RELEASE)
5 1 2
1 8 2
m m
5 3 m
Bend these claws outward
m
for a tight fit, if necessary.
1
Precautions Mounting example (5)
•Choose the installation location carefully so
Installation in the dashboard
that the unit will not interfere with normal
driving operations.
•Avoid installing the unit in areas subject to
dust, dirt, excessive vibration, or high
temperatures, such as in direct sunlight or near
Warning when installing in a car
heater ducts.
without ACC (accessory)
•Use only the supplied mounting hardware for
a safe and secure installation.
position on the ignition key
switch
Mounting angle adjustment
Adjust the mounting angle to less than 60°.
Be sure to press (OFF) on the unit for two
seconds to turn off the clock display after
turning off the engine.
When you press (OFF) only momentarily, the
How to detach and attach the
clock display does not turn off and this causes
battery wear.
front panel (4)
Before installing the unit, detach the front
panel.
RESET button
4-A To detach
Before detaching the front panel, be sure to When the installation and connections are
press (OFF). Press (RELEASE), then pull out the
completed, be sure to press the RESET button
left side.
with a ballpoint pen, etc.
4-B To attach
Attach part A of the front panel to part B of the
unit as illustrated and push the left side into
position until it clicks.
Frequency select switch
The AM (FM) tuning interval is factory-set to the
10 k (200 k) position. If the frequency allocation
system of your country is based on 9 kHz
(50 kHz) interval, set the switch on the bottom of
the unit to the 9 k (50 k) position before making
connections.
(OFF)
B
3
5
5
7
7
7
5
4
(OFF)
4
B
A
B
4
Dashboard
Fire wall
1
4
2
3
4
(OFF)
(RELEASE)
A
Power connection diagram
Auxiliary power connector may vary depending
on the car. Check your car's auxiliary power
connector diagram to make sure the connections
match correctly. There are three basic types
(illustrated below). You may need to switch the
positions of the red and yellow leads in the car
stereo's power connecting cord.
After matching the connections and switched
power supply leads correctly, connect the unit to
the car's power supply. If you have any
questions and problems connecting your unit
that are not covered in this manual, please
consult the car dealer.
Auxiliary power connector
Red
5
Yellow
Yellow
4
Red
7
Red
(OFF)
Yellow
Yellow
4
Red
7
Red
Yellow
the car without ACC position
Red
Yellow
continuous power supply
switched power supply
Red
Yellow
switched power supply
continuous power supply
Red
Yellow