Lighting Procedure - Morso FORNO GAS Instructions Manual

GENERAL INFORMATION
CONNECTING & DISCONNECTING
TO GAS SOURCE
Familiarise yourself with the general information and
safety guidelines located at the front of this manual.
Check
1. Gas cylinder is filled. A sloshing sound will be heard
when shaken.
2. The burner control is in the 'OFF' position
Connecting
1. Ensure valve is in OFF position.
2. Check for any damage to the cylinder connection.
3. Attach the regulator to the cylinder valve.
4. Use a soapy water solution to check the joint. If bub-
bles appear the connection will need to be retight-
ened.
Length Width
575 mm 530 mm
IMPORTANT
• IMPORTANT: Before connecting and disconnecting
barbecue to gas source, make sure burner controls
are in 'OFF' position.
• CAUTION: When the barbecue is not in use, the gas
cylinder must be disconnected.
• Check that the seals between the appliance and the
gas cylinder are in place and in good condition be-
fore connecting the gas cylinder.
• Do not use this appliance if it has damaged or worn
seals.
• NOTE: If for some reason, ignitor fails to produce a
spark at the electrode, barbecue can be lit by a long
barbecue match with hood open insert the match
into a hole on the underside of the barbecue and
turn gas control to high.
• Check performance of burner prior to installing bar-
becue plates.
• Do not smoke when attempting to ignite barbecue.
• Never use volcanic rock, heat beads or other mate-
rial.
• Always use protective gloves when handling hot
components.
8
GARANTI

LIGHTING PROCEDURE

Burner Operation & Ignition System Check
1. With cylinder valve in 'OFF' position check the ig-
niter by pushing in and rotating the control knob
anti-clockwise.
2. If spark is not evident at the burner ignition point,
check that the ignition lead is firmly attached to the
control and to the Ignition needle. Then open cylin-
der valve.
3. With sparking established push and turn the control
knob to 'HIGH'.
4. If the burner fails to light after several attempts turn
off gas and inspect for obstructions to gas flow.
If re–ignition is necessary while the gas barbecue is still
hot, you must wait for a minimum of 5 minutes before
commencing to re–ignite (this allows accumulated gas
fumes to clear).
Height
421 mm
1. PUSK 2. TURN GENTLY