Maintenance - Nanni N5.160 CR2 Operator's Manual

S08

MAINTENANCE

MAINTENANCE
FUEL CIRCUIT
Water in fuel - Pre-filter / Filter Draining
Fuel Filter ( )
2
Fuel injectors - Check Cut out and misfiring with Diagnostic Tool (
Mechanical Fuel injectors ( )
5
LUBRICATION CIRCUIT
Engine oil level ( )
2
Engine Oil ( )
2
Oil Filter ( )
2
Crankcase Ventilation Filter (C.C.V.)
COOLING CIRCUIT
Coolant level ( )
2
Coolant Concentration control ( )
2
Coolant Liquid ( )
2
Thermostat Inspection ( )
2
Calibrated Heat-Exchanger Cap ( )
2
Heat-exchanger - O-Rings
Inter-cooler - O-Rings
RAW WATER CIRCUIT
Raw Water Filter. ( )
2
Raw Water Pump Impeller. ( )
2
Raw water pump Overhaul.
Anodes Check and Replacement. (
2
AIR INTAKE & EXHAUST CIRCUIT
Turbo-charger Inspection
Air Intake Filter ( )
2
Exhaust Mixer Inspection ( )
2
ELECTRICITY / ELECTRONIC
Battery electrolyte level
Electrical Harness Connectors Inspection
Alternator Belt ( )
2
Panel Command : Indicators & Warning Lamps
Read out the Defect Trouble Codes (
WHOLE ENGINE
Engine Mounts Inspection.
Engine Alignment
Hoses / Clamps tightness / Bolts / Nuts Tightening
Visual Inspection (Coolant, fuel, oil, exhaust & raw water leaks)
Valve Clearance
Check Crankshaft Vibration Damper
TRANSMISSION
Transmission Oil level ( )
3
Transmission Oil and Filter ( )
3
Transmission Oil Cooler (if equipped)
( ) Whichever come first (at the first occurrence)
1
( ) Operations to be performed in accordance with user and maintenance manual for your engine. For all technical information specific to your engine, refer to the user and maintenance
2
manual.
( ) Operation to be perform in according with the transmission manufacturer user and maintenance manual.
3
( ) Mechanical injection engines N5.150 - N5.140E - N6.160 - N6.180 - N6.200 - N6.230 - N6.240E - N6.270E - N6.300E are not concerned.
4
( ) Only mechanical injection engines N5.150 - N5.140E - N6.160 - N6.180 - N6.200 - N6.230 - N6.240E - N6.270E - N6.300E are concerned.
5
( ) Only engines N5.150 - N6.160 - N6.180 - N6.200 - N6.230 are not concerned.
6
( ) For N5 and N6 check if the engine is equipped. The crankshaft vibration damper must be replaced after 4500 hours or 5 years whichever come first (at the first occurrence)
7
CHECK/ADJUST/CLEAN/SERVICE/REPLACEMENT IF NECESSARY
COMPONENTS
)
4
)
)
6
( )
7
1
st
Daily Maintenance 250 hours or
100 hours ( )
1
6000 hours or 4 years (
REPLACE
55
PÉRIODICITÉ
Every Every
500 hours or 2000 hours or
1 year ( ) 2 years ( ) 2 years (
1 1
)
1
4 years
When Mount Replacement
Every
)
1