Fitting A Spread Lens - Acclaim Lighting Dyna Accent User Manual

FITTING A SPREAD LENS

The standard beam angle is 6 degrees. This can be adjusted by inserting an appropriate
spread lens into the inside of the front panel.
TO FIT A SPREAD LENS
Notes: This operation is best achieved with the Dyna Accent front face lying horizontally. Install
spread lenses only in dry conditions to avoid any build up of condensation.
1 Using a 3mm Allen wrench (hex key), slightly loosen each of the four bolts that secure the
front hood to the main body of the fixture. Once all bolts have been suitably loosened,
remove all four of them plus their small washers and lift off the front hood.
2 Remove the protective films from both sides of the spread lens.
3 Ensure that the black rubber gasket is correctly in place around the circumference of the
spread lens. Find the Locating tab on one side of the rubber gasket and ensure that this
tab faces towards the front face of the Dyna Accent - and aligns with Locating notch in the
front face.
4 Place the front hood over the spread lens and Dyna Accent front face, ensuring that the
Drain hole of the front hood aligns with the drainage Recess in the rubber gasket of the lens.
5 Reintroduce the four bolts and their washers, and tighten sufficiently.
Drain
hole
Recess
www.acclaimlighting.com
Front hood
Spread lens
Locating tab
Locating notch
7