Fitting A Snoot; Fitting A Spread Lens - Acclaim Lighting Dyna Drum SO QW User Manual

Fitting a snoot

Snoots help to reduce or eliminate light
spill into unwanted areas. The full and
half snoots available from Acclaim
Lighting are attached to the Dyna
Drum SO units in the same way.
1 Using a 3/16" (4mm) hex key,
remove the four bolts that
secure the front ring.
2 Remove the front ring and
place the snoot onto the
front of the fixture. The snoot
mounting holes must align with
the same threads that are used by
front ring. There are also two small
holes either side of the snoot that
must fit onto the small pins either side
of the fixture.
3 Replace the front ring and tighten the bolts evenly.

Fitting a spread lens

You can widen the native beam angle
using an optional spread lens.
1 Using a 3/16" (4mm) hex key,
remove the four bolts that
secure the front ring and
remove the ring.
2 Remove the protective films
on either side of the lens
and place it into the inner
ring of the emitter face. To
allow water drainage, the
four notches of the lens' rubber
surround must face outwards
and be fully aligned with the open
grooves of the fixture's mounting
ring (also the frosted side of the lens
must face inwards towards the emitters).
3 Replace the front ring and tighten the bolts evenly.
Note: It is possible to use both a spread lens and a snoot. Fit the lens first and then add the snoot.
Tip: Adding accessories is much easier if the Dyna Drum SO front face is pointing vertically upwards.
IMPORTANT: Ensure the notches are facing
outwards and are fully aligned with the
grooves of the fixture's inner ring. The
frosted side of the lens
Full or half
snoot
must face inwards to
the emitters.
Spread lens with
rubber surround
5