Motor Removal - Panasonic MC-CG695-ZA76 Service Manual

4.5.

Motor removal

1. Remove the motor support rubber (rear) from the motor
support front.
2. Remove the two screws from the motor support front.
3. Remove the motor support front from the motor unit.
4. Remove the motor support rubber (front) from the motor
unit.
5. Remove the noise suppressor U from the motor unit.
6. Remove the two lead wires from the motor unit.
Note:
Make sure that the thermal protector is on the under-
side when setting the assembled motor into the lower
body.
8