Reckeen ADB 100 Instruction Manual page 22

| USER GUIDE
MIC input Jack 6,3 mm stereo. Picture below.
In Configuration Window you can find Microphone settings for the microphone connected to AUDIO
BOX panel (ADB -100).Picture below. There are two operating modes: a None mode with a dynamic
microphone, for which you can set the Gain value with a slider, and a Phantom mode with a condenser
microphone. When you switch to the Phantom mode, you will be warned that a voltage of 48 V will be
applied to the speech insert. A red LED lights up on the ADB 100.
Warning ! It is recommended not to connect or disconnect a microphone to the ADB-100 during the time
the red LED is lit up. You can safely connect a microphone only in NONE mode.
Headphone output Picture below.
Headphone connector is Jack 6,3 mm stereo. The Mute function works for each input source and the
master output. Selected sources are mixed, and create a Master Out signal. On the Headphones you can
hear the signal from any input or Master Out output. In this case, the Mute function will not work for the
Headphones, despite the checkboxes are on . You can listen any channel on the Headphones with Mute
function enabled. Picture below.
22