Manual Gain Control - Uniden U60P 4G Instruction Manual

Contact Tech Support at 1.800.215.7015 or email at support@unidencellular.com
GAIN CONTROL INSTRUCTIONS
Your Uniden Cellular Signal Booster is equipped with a SMART function that
automatically adjusts the gain of the booster for optimum performance.
Your booster comes with the SMART function disabled. To enable the SMART
function, you simply push the SMART button on the LCD interface.
Most booster installations do not need do anything else except plug it in to
power and let the booster do its job
Some installation requires the need to adjust the gain manually. Your booster
has this function as well. You adjust the gain manually for each cellular frequency
band.
The MGC (Manual Gain Control) feature give you full control over the amount
of gain your device is emitting. This function is extremely helpful in certain
instances when your input signal from one frequency is much stronger than the
other. This can cause oscillation (interference).
Your booster will automatically override all gain control in order to protect the
cellular network from receiving interference and will shut itself down should it
detect any interference.
Follow the following instructions to manually adjust the gain:
1. Turn Off the SMART function. Push the SMART button on the LCD
interface.
2. Select the center frequency of the band to adjust. Push the ENTER
button to cycle through the 5 different frequency bands until the desired band is
in focus.
3. Push the GAIN increase or GAIN decrease button to adjust.
4. Push the ENTER button to confirm.
5. Redo steps 2 to 4 for all remaining frequency bands.
** enabling the SMART function will remove all manually set gain controls.
26