Adjusting The Volume Of The Bass And Treble; Listening To Each Programme Source In Its; Registered Surround Menu; Last Sound Memory (Lsm) - Sony CDX-C910 Operating Instructions Manual

Adjusting the volume of
the bass and treble
You can adjust the volume of the bass and
treble to best fit the acoustic characteristics
inside your car.
1
Press (SOURCE) to select a source (radio,
CD or MD).
2
Press (SOUND) repeatedly until "BAS" or
"TRE" appears.
3
Rotate the dial to adjust the volume.
After three seconds, the display goes back
to the normal playback mode.
Adjusting the turn-over frequency
You can adjust the bass and treble turn-over
frequencies.
Turn-over frequency
EN
1
Press (SOURCE) to select a source (radio,
CD or MD).
2
Press (SOUND) for two seconds.
3
Press (SOUND) repeatedly until "BAS" or
"TRE" appears.
Bass adjusting mode
BAS
EQ SUR
Treble adjusting mode
TRE
EQ SUR
4
Rotate the dial to select the turn-over
frequency.
The turn-over frequencies change as
follows:
Bass:
198 Hz n 250 Hz n 314 Hz* n 396 Hz
Treble:
2.0 kHz n 3.1 kHz* n 4.0 kHz n 5.0 kHz
* Factory-set frequency
22
Actual total number:
Frequency (Hz)
314 Hz
3.1kHz
5
Press (SOUND) for two seconds.
The display goes back to the normal
playback mode.
Listening to each
programme source in its

registered surround menu

— Last Sound Memory (LSM)

You can listen to the same source always in the
same surround menu even after changing the
programme source or turning the unit on and
off again.
Changing the line output
level
You can change the line output level if you
distortion or other noise.
1
Press (SHIFT), then press (2) (SET UP)
until "L.out" appears.
2
Press (4) (n) to select the desired
setting (–10 dB or –16 dB).
3
Press (SHIFT).
Sony CDX-C910 (E,S,C) 3-856-715-11 (2)