Maintenance; Dismounting The Unit - Sony CDX-C7850 Operating Instructions Manual

Maintenance

Fuse replacement
When replacing the fuse, be sure to use one
that matches the amperage described on the
fuse. If the fuse blows, check the power
connection and replace the fuse. If the fuse
blows again after replacement, there may be an
internal malfunction. In such a case, consult
your nearest Sony dealer.
Warning
Never use a fuse with an amperage rating
exceeding the one supplied with the unit as
this could damage the unit.
Cleaning the connectors
The unit may not function properly if the
connectors between the unit and the front
panel are not clean. To prevent this, open the
front panel by pressing (OPEN), then detach it
and clean the connectors with a cotton swab
dipped in alcohol. Do not apply too much
force. Otherwise, the connectors may be
damaged.
Back of the front panel
Notes
For safety, turn off the engine before cleaning
the connectors and remove the key from the
ignition switch.
Never touch the connectors directly with your
fingers or any metal device.
30
Fuse (10 A)
Main unit

Dismounting the unit

1
Press the clip inside the front cover with
a thin screwdriver, and lever the front
cover free.
2
Repeat step 1 on the left side.
The front cover is removed.
3
Use a thin screwdriver to push in the clip
on the left side of the unit, then pull out
the left side of the unit until the catch
clears the mounting.
4
Repeat step 3 on the right side.
5
Slide the unit out of the mounting.