Controls - Lawn Solutions Turf Revitalizer Owner's Manual

 Seed Meter Gauge – The "Seed Meter
Gauge" is used to adjust the seed flow to a set
flow rate. It is calibrated so that you receive
the correct amount of seed at any cruising
speed. (i.e. – the seed flow is proportional to
the ground speed)See figure 7.
 Operator Kill Switch (Lanyard type) – The
"Operator Kill Switch" is to be used at all
times when the engine is running. Place the
lanyard around your wrist or connect securely
to your clothing. If the operator should lose
control of the machine, the lanyard will be
released from the kill switch stopping the unit.
See figure 8.
 Operator Kill Switch (Operator handle kill
switch type) – The handle needs to be held
down when starting the engine and must
continue to be held during operation. If the
operator should lose control of the machine,
release your hand from this switch and the
engine will stop running. See figure 9.
Figure 7.
Figure 8.
Figure 9.
- 8 -