Other Functions; Adjusting The Sound Characteristics; Attenuating The Sound; Changing The Sound And Beep Tone - Sony CDX-3170 Operating Instructions Manual

Other Functions

Adjusting the sound
characteristics
You can adjust bass, treble, balance and fader.
Each source can store the bass and treble level
independently.
1
Select the Y-em you want to adjust by
pressing (SEL) repeatedly.
VOL (volume) n BAS (bass) n TRE (treble)
n BALANCE (left-right) n FADER
(front-rear)
2
Adjust the selected item by pressing (+)
or (–).
EN
Adjust within three seconds after selecting
the item. (After three seconds, the buttons
work as volume control buttons.)

Attenuating the sound

Press (ATT).
"ATT" flashes.
To restore the previous volume level, press
(ATT) again.
8
Changing the sound and
beep tone
Enjoying bass and treble even at
low volume — Loudness
Bass and treble will be reinforced.
Press (2) while pressing (SEL).
"LOUD" appears in the display.
To cancel, press these buttons again.
Attenuating the beep tone
Press (6) while pressing (SEL).
To obtain the beep tone again, press these
buttons again.
Note
If you connect an optional power amplifier and do
not use the built-in amplifier, the beep tone will
be disabled.
Turning on the clock
display

— Power Select Function

Only for cars with an accessory position on the
ignition key switch
To turn the Power Select Function ON
Press (OFF) while pressing (SEL).
The Power Select Function ties the clock
display power to the accessory position on
the ignition key switch.
To avoid battery wear, the clock is not
displayed while the unit is initializing.