Hardware Installation Manual
5.4
Connecting to FXO Interfaces
The procedure below describes how to connect the FXO port interfaces to telephone
exchange analog lines or PBX extensions.
Warnings:
Note:
An RJ-11 cable connector with the following pinouts is used:
To connect to FXO interfaces:
Using an RJ-11 connector, connect the FXO port/s to the required telephone interface.
Version 6.6
•
To protect against electrical shock and fire, use a 26 AWG min wire to
connect FXO ports to the PSTN.
•
Ensure that FXO ports are connected to the appropriate external
devices; otherwise, damage to the device may occur.
•
FXO ports are considered as TNV-3.
This section is applicable only if your device is installed with an FXO module.
Figure 5-3: RJ-11 Connector Pinouts for FXO
23
5. Cabling the Device
April 2012