60G40-5-7-2
ON-VEHICLE SERVICE
EXCESSIVE PEDAL TRAVEL CHECK
1) Start engine.
2) Depress brake pedal a few times.
3) With brake pedal depressed with approximately 30 kg (66 lbs)
load, measure brake pedal to wall clearance "c".
Clearance "c": Over 80mm (3.15 in.) ... For 1.3 – 1.6 model
4) If clearance "c" is less than specification, the most possible
cause is either rear brake shoes are worn out beyond limit or air
is in lines.
Should clearance "c" remain less than specification even after
replacement of brake shoes and bleeding of system, other pos-
sible but infrequent cause is malfunction of rear brake shoe ad-
justers or booster push rod length out of adjustment.
D See "BLEEDING BRAKES" in this section.
D Remove brake drums for adjuster inspection. (See "BRAKE
DRUM REMOVAL" in this section.) If defective, correct or re-
place.
95 mm (3.74 in.) ... For 1.8 model
BRAKES 5-7