Other Guidelines; Verifying Package Contents - Cisco 910 Installation Manual

Cisco 910 Industrial Router Installation
Preparing for Installation

When other equipment is installed on or connected to the router, try operating the router by itself, if possible. Power
off other equipment (such as USB devices and installed third-party modules) to allow the router a maximum of
cooling air and clean power.

Other Guidelines

When determining where to place the router, observe these guidelines:

Before installing the router, first verify that the router is operational by powering it on and running POST. Follow the
procedures in Verifying Router

Operating environment is within the ranges listed in the

Clearance to front panels meets these conditions:
— Front-panel LEDs can be easily read.
— Access to ports is sufficient for unrestricted cabling.
— Front-panel direct current (DC) power connector is within reach of the connection to the DC power source.

Airflow around the router and through the vents is unrestricted. To prevent the router from overheating, there must
be a minimum clearance of 3 in. (76 mm).

Temperature surrounding the unit does not exceed:
— 140°F (60°C) (with SSD)
— 140°F (60°C) (without SSD card and in a sealed enclosure)
— 158°F (70°C) (without SSD card and in a vented enclosure)

Cabling is away from sources of electrical noise, such as radios, power lines, and fluorescent lighting fixtures.

Verifying Package Contents

Carefully remove the contents from the shipping container, and check each item for damage. If any item is missing or
damaged, contact your Cisco representative or reseller for support. Return all packing materials to the shipping container
and save them.
The router is shipped with these items:

Printed documentations include:
— Cisco 910 Industrial Router Quick Start Guide
— Pointer Card for the Cisco 910 Industrial Router

Two DC power connectors

DIN mounting kit, preinstalled at the rear of the device

3G antenna (only for IR910G-K9 and IR910G-NA-K9)

Wi-Fi antenna (only for IR910W-K9)

3G or Wi-Fi antenna wire clip (only for IR910G-K9, IR910G-NA-K9, and IR910W-K9)
The following items can be ordered separately and are not included by default with the chassis:

External storage (model number: ACC-IR910-S16)—SSD media with 16 GB capacity
Operation.
Technical Specifications for the Cisco 910 Industrial Router.
24