Step-By-Step Home Brewing; Assembling The Fermenter; Cleaning The Fermenter - KegLand Beginner’s Home Brew Starter Kit Manual

Step-by-step home brewing

This is a great video run-through on how to get your first batch brewing:
Now that we have gone over the 3 golden rules of brewing, we can begin making our precious liquid-gold!
Please ensure you read and comprehend these instructions thoroughly before beginning.

1. Assembling the fermenter:

Once you have unboxed your KegLand beginner's home brew kit and
checked everything is included, begin by assembling your fermenter.
The Black Plastic Fermenter Tap will screw into the threaded port at
the bottom of your large white 30L HDPE fermenter. Sometimes
there's a little white plug installed in the tap hole; this can be easily
removed with the flat rear part of a spoon. If the inside of the hole is
undrilled, this can easily be drilled out at home with a ~10mm drill bit.
The Black Rubber Grommet fits tightly in the hole on the lid to
provide a leak-free seal for the included Air Lock that squeezes into
the grommets hole.
The Stick-On Thermometer should be stuck on the outside of the
fermenter. We suggest putting it next to the volume markings
between the 10L and 20L markings.

2. Cleaning the fermenter:

The fermenter comes ready-to-sanitise right out of the box so this step may be skipped if so. If it is not your
first time using it, it may need to cleaned first.
For caked on yeast, dust, dirt or grime, cleaning can be done by filling the rinsed-out fermenter with hot tap
water up to the brim and emptying in the included sachet of Powerful Brewery Wash (PBW) and mixing well.
https://youtu.be/74OMIqDdrkU?t=93
Page 6 of 17