Subscribe to Our Youtube Channel
Related Manuals for KegLand Benchy Nitro KL35118
Summary of Contents for KegLand Benchy Nitro KL35118
- Page 1 Benchy Nitro - Instruction Manual ‘ KL35118 Instruction Manual KegLand Distribution PTY LTD www.KegLand.com.au www.KegLand.com.au Last Updated 15/03/2024 3:10 PM Page 1 of 9...
- Page 2 AVOID EXTERNAL HEAT SOURCES SUCH AS DIRECT SUNLIGHT, GAS STOVES OR OTHER HEAT GENERATING APPLIANCES. WARNING ONLY USE KEGLAND APPROVED CLEANERS AND SANITISERS TO CLEAN THE PRODUCT LINES. WARNING DO NOT SET TEMPERATURE TO MAX COLD WHEN DISPENSING LOW ABV...
-
Page 3: Installation Requirements
Benchy and tighten the shank collar using the supplied Facet Tap Wrench/Spanner Tool. Install the drip tray and connect the IEC power cord into the IEC socket on the back of the Benchy Nitro (do not turn on the power switch yet) www.KegLand.com.au Last Updated 15/03/2024 3:10 PM Page 3 of 9... - Page 4 Stanley knife or 2 in 1 tube cutter (KL07689). 4. Insert the two pieces of 9.5mm OD tubing into the 9.5mm elbows and install the blue locking circlips onto the elbow. www.KegLand.com.au Last Updated 15/03/2024 3:10 PM Page 4 of 9...
-
Page 5: Adjusting Set Temperature
The best is to keep the set temperature in the middle of the WARM and COLD range and make small adjustments to hit your desired beverage temperature. www.KegLand.com.au Last Updated 15/03/2024 3:10 PM Page 5 of 9... -
Page 6: Cleaning & Maintenance
After you connect nitrogen to the N2 inlet the Benchy Nitro will automatically switch from using nitrogen in the air to using nitrogen from your Nitrogen cylinder. CLEANING/MAINTENANCE Only use KegLand approved cleaners such as StellarOxy StellarClean and sanitisers such as... - Page 7 Benchy Nitro Off. Then undo the tap from the shank using the supplied faucet spanner. Unscrew the spout and remove the o-ring, aerator disc and regulation cone. www.KegLand.com.au Last Updated 15/03/2024 3:10 PM Page 7 of 9...
-
Page 8: Troubleshoo
4. If dispensing coffee make sure that the filter, keg dip tube, posts , disconnects or tap on the unit are not clogged.. 5. Ensure the air control valve (foam amount) is not set too high. www.KegLand.com.au Last Updated 15/03/2024 3:10 PM Page 8 of 9... - Page 9 For a full terms and conditions, please visit our website here -> Terms & Conditions For technical support with the Benchy Nitro please email www.KegLand.com.au Last Updated 15/03/2024 3:10 PM Page 9 of 9...
Need help?
Do you have a question about the Benchy Nitro KL35118 and is the answer not in the manual?
Questions and answers