GhostEye 200M Manual Book page 11

Quick Start Guide
3. Turn on the power switch to start
power supplying.
Power Switch: ON turn on
4.Press "CH" button to select the corresponding working channel of
receiver and then press "OK" button for confirmation.The LED digits
display will display one of the characters from 1 ~ 9, A and b when the video
signal of device is normal.(Tx and Rx use same default working channel)
5. The transmitter supports manually switching the SDI audio input mode by
long pressing "OK" button. (Notice: This function is only valid for SDI
audio input and won't affect the HDMI audio input.)The default value of
SDI audio input mode is 0 and the decimal point will be set to be non-bright
under this mode; long press "OK" key button for more than 3 seconds,
and then the LED digits display will display SDI audio input mode as 1 while
the decimal point will be bright.
Audio input mode 0: adopt internal SDI clock signal of TX
Audio input mode 1: adopt SDI clock signal of SDI input signal
© 2018 Cine Gears INC. All Rights Reserved.
OFF turn off
Installation
8