Page 2
Trademarks Ghost-Eye Wireless Video Transmission SystemsTM are trademarks of Cine Gears Inc. Web Interface. Statement of Conditions In the interest of improving internal design, operational function, and/or reliability, Cine Gears Inc. reserves the right to make changes to the products described in this document without notice.
Features . Uses 5GHz ISM frequency band, maximum 10 frequency channels selection, coexist with WIFI. . Highest resolution supports color depth of up to 30 bits(10 bits/color), . HDMI and SD/HD/3G SDI input and output, HDMI & SDI cross conversion is supported.
Page 8
Installation 1) Ensure the video source output of the camera is OK, and the HD monitor is powered on and switched to connected video input port. 2) Ensure 2 TX antennas are installed. For optimal results set the dual antennas in the form of a “V” and maintain unobstructed line of sight between transmitter and receiver.
Page 9
Installation Installation 7) Before RX nished wireless link with TX, 5 RSSI indicators and VIDEO indicators are o ; when wireless link is done, RSSI indicators will light rst and indicate the signal strength. If the receiver detects wireless video normal internally from air inferface, VIDEO indicator will light.
Page 10
Installation The wireless transmission system works in the 5.1-5.9GHz frequency band and can be exibly con gured to other licensed or ISM bands to accommodate di erent global regions. The front panel of the transmitter features a frequency selection button (see below illustration), which provides a maximum of 4 workable frequency channels, and supports a maximum of 4 simultaneous receiver units.
Troubleshooting Guide Step 1 Step 4 Step 2 Step 3 If the transmission system can’ t establish link at long distance but works If the pr oblem is not If the pr oblem is not If established link at The syst em well at shorter distance.
Warning ● Do not expose this device to extreme hot, cold, dusty or humid environments. ● Do not scratch the device with sharp objects. ● Do not drop this device from high place, as this may cause hardware damage. ● This device is designed for non-waterproofing. Please do not allow any liquid to penetrate into the device.
Specification Transmitter Receiver SDI Input(BN C female); SD I O utput(BN C fem ale); Int er face H DM I Input(Type A female); H D M I O utput(Type A fem ale); 2 Antenna port(R P- SM A male); D C input(4pin LEM O fem ale) DC input(4pin LEM O female) 7-36V DC Supply Voltage Range...
Disclaimers FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Page 15
Disclaimers Terms and Conditions Congratulations on purchasing your new CINEGEARS product. Please read this manual carefully before using the product. By using this product, you hereby agree to this disclaimer and signify that you have read it in full. You agree that you are responsible for your own conduct and any content created while using CINEGEARS products, and for any consequence thereof.
About Cinegears Cine Gears Inc. is an industry leading company that designs and manufactures digital wireless follow focus systems, lens control systems, camera motion control systems and accessories for film and broadcast industry. As a big believer in the power of creativity and ideas, we designed the Pegasus cablecam, the wireless motor drive that integrated a built in wireless transmitter, and the wireless finger wheel controller.