Installation
1) Ensure the video source output of the camera is OK, and the HD monitor
is powered on and switched to connected video input port.
2) Ensure 2 TX antennas are installed. For optimal results set the dual
antennas in the form of a "V" and maintain unobstructed line of sight
between transmitter and receiver. Below gure for your reference.
3) Ensure all input, output SDI or HDMI cables are connected.
4) Ensure both transmitter and receiver are powered via battery or DC input.
Then turn on power switch of the transmitter and receiver respectively. The
POWER indicator will then light.
5) Ensure the transmitter and receiver is set with the same frequency.
6) If the camera is on and video input is OK, TX side VIDEO indicator will light.
© 2018 Cine Gears INC. All Rights Reserved.
LINK
VIDEO
CH
OK
5