Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for GAS PRO Series
Summary of Contents for GAS PRO Series
- Page 1 PRO SERIES HIGH PERFORMANCE AUDIO AMPLIFIER 80.2 / 80.4 / 600.1 / 1000.1 / 2000.1 OWNER’S MANUAL...
- Page 2 Always use a rubber grommet to prevent the power wire from shorting and to reduce the risk of fire. Depending on which of the GAS PRO amplifiers you are connecting, use the right size of power and ground wires.
- Page 3 There is no correct gain setting. Because speakers require different power demands to reach the same output, the gains most often need to be used to compensate for these differences. If you tried to set all the gains at half way you would probably find the sys tem didn't sound very good.
- Page 4 1. Before you start, disconnect the negative cable from the car battery. Tape 8. Connect the remote wire from the head unit to the amplifier. Now is a good up the end so it is isolated form the battery. time to turn on the amp for the first time. Make sure it turns on properly and does not go into protection.
- Page 5 PRO80.2 PRO80.2 Stereo 2 Channel Full Range Bridged Mono Subwoofer Use This Set Bass Boost Set Bass Boost Set To Full Crossover To 0dB As Needed Set To LP For LP 4OHM 4OHM 4OHM 4OHM 4OHM...
- Page 6 PRO80.4 PRO80.4 Stereo HPF With Mono Subwoofer Stereo 4 Channel Full Range Use This Use This Crossover Set Bass Boost Set Bass Boost Set Bass Boost Set To LP Crossover Set To FULL For LP To 0dB As Needed To 0dB Set To HP For HP 4OHM...
- Page 7 PRO600.1 PRO1000.1 PRO2000.1 1ohm Stable Mono Subwoofer Amp PRO2000.1 (Power terminals) Adjust Subsonic Set For Best Set Bass Boost Filter To Prevent Bass Responce Frequency As Needed Woofer Damage 1–4 OHM Use 250A external fuse Adjust Gain Set Bass Boost Low Pass Carefully As Needed...
- Page 8 Before removing your amplifier, refer to the list below and follow the MODEL PRO80 2 PRO80 4 PRO600.1 PRO1000.1 PRO2000.1 suggested procedures Always test the speakers and their wires first. ITEM RMS POWER into 4 Ω 14.4V 2x80W 4x80W 1x250W 1 40 1x650W Check for good ground connection...
Need help?
Do you have a question about the PRO Series and is the answer not in the manual?
Questions and answers